UNIFIED COMMUNICATIONS TECH TIP
VoIP power calculator
Tom Lancaster
01.19.2006
Rating: -4.00- (out of 5)
|
For the past several years, one of the lurking gotchas to implementing VoIP was supplying enough power. The problem was most noticeable in densely populated user areas where large, chassis-based switches -- which can offer hundreds of Ethernet ports for users -- were used. These switches typically run off two or three power supplies. Of course, the expectation is that at least one of these supplies power for redundancy, so that means we're really asking a single supply to provide enough juice for the switch itself and all its line cards and all the phones and other Power over Ethernet (PoE) devices that are attached to it, such as WAPs.
Reality has been that few of these power supplies had sufficient output to run a full compliment of phones at the specified ratings. (The different PoE specs have a variety of maximum outputs.) Fortunately, few have run into problems because few organizations fill up these chassis with phones on every port, and phones don't necessarily pull the maximum power all the time, so this issue, while real, was seldom discussed.
Recently, the situation has improved, as power supplies with obscenely high output are now available so that it may now be possible to get all the power you need (Important safety tip: Do not touch your tongue to a 4200W power supply).
However, you should still do a power budget whenever you are planning a VoIP deployment, just like you do a budget for your voice trunks and QoS bandwidth and delay. To start, check to see if your switch vendor has a power calculator. For example, Cisco's very handy tool can be found here.
To do a power budget without access to a handy calculator, you would of course
use the formula "Watts = Volts * Amps." Aggregate the power consumption
for all the devices you intend to plug into the switch, and then compare
that to the ratings on your power supplies. Don't forget to include
the power required by the switch itself. But in any case, you should
check with the manufacturer, because there can be a lot of little gotchas.
Since these new supplies can be expensive, you'll want determine which one you need before you buy. If you're rolling out VoIP on existing boxes, you should calculate your power requirements to determine if you need to upgrade your supply before you do your deployment.
|
|
Rate this Tip
|
To rate tips, you must be a member of SearchUnifiedCommunications.com.
Register now
to start rating these tips. Log in if you are already a member.
|
DISCLAIMER: Our Tips Exchange is a forum for you to share technical advice and expertise with your peers and to learn from other enterprise IT professionals. TechTarget provides the infrastructure to facilitate this sharing of information. However, we cannot guarantee the accuracy or validity of the material submitted. You agree that your use of the Ask The Expert services and your reliance on any questions, answers, information or other materials received through this Web site is at your own risk.
|
|
|
|
|
|
|
